eneltec Logo eneltec Logo

Electrical wiring instructions for Black Beetle Basic - back to top

IMPORTANT:

Please ensure that the information contained in this leaflet is passed on to the user/maintenance engineer.
C.B/fuse must be connected according to the value written in the spec.
Short circuit in any wires of the controller themselves or to the Earth will cause permanently damage to the controller.
All the wires must be connected into protect place from electric shock.
The product must be installed by a qualified person in accordance with the current building/site and wiring instruction.

Installation instructions for Black Beetle DALI - back to top

Description:

The Energy Saving Controllers designed for installation as additional device for HID Street Light fixture that based on magnetic ballast and PF capacitor.
The controllers operating the HID Street Light fixture at saving voltage ranges resulting with reduction of the power consumption &lighting. The output voltage will be set automatically to nominal voltage at every start or restart for 5 minute.
The controllers are multi power reduction and designed to reduce the output voltage down to 190VAC.
The available output voltages: 230V, 210V, 205V, 200V, 195V, 190V.
The output voltage stabilizes at range of ±2%.
The output can set to the requested voltage by local P.C or remote control system.
The input/output queries are according to the DALI standard.
These controllers enable the implementation of savings per lamp respectively by reducing the lighting intensity according to the road lighting standard.
The controller pack in plastic housing, connected via a 350mm cable to the supply voltage, load and DALI communication.

Mechanical details:

P.N size dimensions L- W-H
EN-DC-1-150 131x95x81
EN-DIC-1-250 146x108x90
EN-DIC-1-600 158x120x98
EN-DIC-1-1000 176x134x98
The size dimensions @ mm





IMPORTANT:

Please ensure that the information contained in this leaflet is passed on to the user/maintenance engineer.
C.B/fuse must be connected according to the value written in the table in this document.
Short circuit in any wires of the controller themselves or to the Earth will cause permanently damage to the controller. All the wires must be connected into protect place from electric shock.

Electrical Installation:

The product must be installed by a qualified person in accordance with the current building/site and wiring instruction.
After disconnecting the supply voltage, please connect the 6 controller’s wires as follows:
Line Input: P – Orange or Brown, N – Blue.
Load Output: PL – Black, NL – Red.
DALI: Green & White.
Connect a DALI system: This allows two wire communication between the controller and a central monitoring or control system designed to meet the requirements of DALI standard.

Indication LED:

Green light-ON, Green blink-OFF, Red light-over temperature.
Red fast blinking-line voltage out of the limit, Red slow blinking -over current.

Examples of mounting trays - back to top

Black beetle basic compatible for existing lighting - back to top

Installation:

  • The controller supplied with 50 cm input cable.
  • Fast installation in the base of the lighting pole.
  • Combined with local control device – option.
  • Combined with remote control system – option.
Energy Saving

Electrical scheme

Energy Saving

Black beetle DALI compatible for existing lighting - back to top

Energy Saving

Installation:

  • ✔ Block terminals for wiring connections.
  • ✔ Fast installation in the base of the lighting pole.
  • ✔ Combined with local control device – option.
  • ✔ Combined with remote control system – option.



Mechanical details:

P.N size dimensions L- W-H
EN-DC-1-150 131x95x81
EN-DIC-1-250 146x108x90
EN-DIC-1-600 158x120x98
EN-DIC-1-1000 176x134x98
The size dimensions @ mm